Auto Mode Readiness


Device: MiniMed™ 670G insulin pump (MMT-1780K)

The Auto Mode Readiness screen indicates whether your pump is ready to enter Auto Mode, or return to Auto Basal from Safe Basal.

To check Auto Mode Readiness:

  1. Press Select and select Status to go to the Status screen.

    Select Status screen

  2. Select Auto Mode Readiness.

    Select Auto Mode Readiness screen

The following table shows what to do when the wait icon or the question icon appear by items on the Auto Mode Readiness status screen.

Auto Mode Readiness status screen

Line If this appears Do this
1 Calibration required Perform a fingerstick and calibrate your sensor.
BG required Perform a fingerstick and enter a new BG.
Wait to enter BG Wait until the pump prompts you to enter a BG.
Processing BG Wait until the BG has processed.
2 Auto Mode turned off Turn on Auto Mode in the SmartGuard Auto Mode screen.
3 Sensor not ready Do the following:
  • Check to see if your pump has a transmitter ID entered in Utilities, Device Options, for example, GT6133333M. Make sure your pump is connected to a transmitter.
  • Check your Home screen. If you see , move your pump and transmitter closer together. The pump will try to find the transmitter signal.

    If after 30 minutes the pump and transmitter are still not communicating, you will receive a Lost sensor signal alert. Check that the sensor is still inserted in the skin, and the transmitter and sensor are still connected.

    Move your pump closer to your transmitter.
  • If your SG is outside of the 40-400 mg/dL range, your pump will not enter Auto Mode.
Sensor off Turn on the sensor in the Utilities, Sensor Settings screen.
Airplane mode on Turn off the Airplane Mode in the Utilities, Airplane Mode screen.
4 Bolus in progress Wait until the bolus is complete or stop the bolus yourself before Auto Mode can activate.
5 Delivery suspended If insulin delivery is suspended, Auto Mode cannot activate. Treat low BG if necessary as instructed by your healthcare professional.
6 Carb ration not set Enter your Carb Ratio in the Bolus Estimate Setup screen or the Bolus Wizard Setup screen.
7 Temp Basal rate If a Temp Basal is currently active, you must wait until it has completed or cancel the temp basal yourself before Auto Mode can activate.
8 Active insulin updating If active insulin is currently updating, it may take up to 5 hours to complete. You must wait until this amount is updated before Auto Mode can activate.
9 Auto Mode warming up Auto Mode is gathering information on your insulin delivery history in order to personalize its automatic delivery of insulin.