Setting Temp Target in SmartGuard^™ technology

Device: MiniMed^™ 780G insulin pump

You can set a temporary sensor glucose (SG) target (Temp Target) of 150 mg/dL for situations when less insulin is needed, such as exercise. Check with your healthcare professional regarding the use of Temp Target.

Note: The Auto correction feature is not active during an active Temp Target. It will resume after the Temp Target is complete.

To set a Temp Target:

1. From the Home screen, press and select .
2. Select Temp Target to turn the feature on or off.
3. Use the Up and Down arrows to set the Duration, from 30 minutes to 24 hours, in 30-minute increments.

4. Select Start.

   

   The screen shows Temp Target Started, and then changes to the Home screen, where a banner shows the remaining Temp Target time.

   

   When the Temp Target time runs out, the banner disappears from the Home screen*.

   * This is the SmarGuard™ feature home screen with Guardian™ 4 sensor. If using the Guardian™ Sensor 3, your home screen may look slightly different.

To cancel Temp Target:

1. From the Home screen, press and select .

2. Select Cancel Temp Target.

   

The Temp Target will be canceled, and the Home screen will appear, with no Temp Target banner.