ALERT: Due to the inclement weather across much of the country, Medtronic deliveries are currently experiencing delays and there will be longer than normal hold times on the phone. Visit www.Diabetes.Shop if you need to place an order, get a sensor or belt clip replacement, or check the status of your supply order. X

MiniMed 630G System Support

Sensor Connected


Sensor connected. If new sensor, select Start New. If not, select Reconnect.

What has happened: The transmitter has detected that you have connected a sensor. The pump needs to know if this is a new sensor or if you have reconnected your old sensor.

Next steps

  • If you have connected a new sensor, select Start New Sensor.
  • If you have reconnected a sensor you have been using, select Reconnect Sensor.
  • In either case, a “warm-up” message appears on your Home screen, and you are prompted to calibrate your sensor. Your pump starts receiving your SG values again after the two-hour initialization is complete.

Sensor connected. Start new sensor.

What has happened: The transmitter has detected that you have connected a sensor.

Next steps